The EvChild class

(PECL ev >= 0.2.0)


EvChild watchers trigger when the process receives a SIGCHLD in response to some child status changes (most typically when a child dies or exits). It is permissible to install an EvChild watcher after the child has been forked(which implies it might have already exited), as long as the event loop isn't entered(or is continued from a watcher), i.e. forking and then immediately registering a watcher for the child is fine, but forking and registering a watcher a few event loop iterations later or in the next callback invocation is not.

It is allowed to register EvChild watchers in the default loop only.

Короткий Огляд Класа

EvChild extends EvWatcher {
/* Властивості */
public $pid ;
public $rpid ;
public $rstatus ;
/* Успадковані властивості */
public $is_active ;
public $data ;
public $is_pending ;
public $priority ;
/* Методи */
public __construct ( int $pid , bool $trace , callable $callback [, mixed $data = NULL [, int $priority = 0 ]] )
final public static object createStopped ( int $pid , bool $trace , callable $callback [, mixed $data [, int $priority ]] )
public void set ( int $pid , bool $trace )
/* Успадковані методи */
public int EvWatcher::clear ( void )
abstract public EvWatcher::__construct ( void )
public void EvWatcher::feed ( int $revents )
public EvLoop EvWatcher::getLoop ( void )
public void EvWatcher::invoke ( int $revents )
public bool EvWatcher::keepalive ([ bool $value ] )
public void EvWatcher::setCallback ( callable $callback )
public void EvWatcher::start ( void )
public void EvWatcher::stop ( void )



Readonly . The process ID this watcher watches out for, or 0 , meaning any process ID.


Readonly .The process ID that detected a status change.


Readonly . The process exit status caused by rpid .


add a note add a note

User Contributed Notes

There are no user contributed notes for this page.
To Top