The Event class

(PECL event >= 1.2.6-beta)

소개

Event class represents and event firing on a file descriptor being ready to read from or write to; a file descriptor becoming ready to read from or write to(edge-triggered I/O only); a timeout expiring; a signal occuring; a user-triggered event.

Every event is associated with EventBase . However, event will never fire until it is added (via Event::add() ). An added event remains in pending state until the registered event occurs, thus turning it to active state. To handle events user may register a callback which is called when event becomes active. If event is configured persistent , it remains pending. If it is not persistent, it stops being pending when it's callback runs. Event::del() method deletes event, thus making it non-pending. By means of Event::add() method it could be added again.

클래스 개요

final Event {
/* Constants */
const integer ET = 32 ;
const integer PERSIST = 16 ;
const integer READ = 2 ;
const integer WRITE = 4 ;
const integer SIGNAL = 8 ;
const integer TIMEOUT = 1 ;
/* 프로퍼티 */
public readonly bool $pending ;
/* 메소드 */
public bool add ([ double $timeout ] )
public bool addSignal ([ double $timeout ] )
public bool addTimer ([ double $timeout ] )
public __construct ( EventBase $base , mixed $fd , int $what , callable $cb [, mixed $arg = NULL ] )
public bool del ( void )
public bool delSignal ( void )
public bool delTimer ( void )
public void free ( void )
public static array getSupportedMethods ( void )
public bool pending ( int $flags )
public bool set ( EventBase $base , mixed $fd [, int $what [, callable $cb [, mixed $arg ]]] )
public bool setPriority ( int $priority )
public bool setTimer ( EventBase $base , callable $cb [, mixed $arg ] )
public static Event signal ( EventBase $base , int $signum , callable $cb [, mixed $arg ] )
public static Event timer ( EventBase $base , callable $cb [, mixed $arg ] )
}

프로퍼티

pending

Whether event is pending. See About event persistence .

예약 상수

Event::ET

Indicates that the event should be edge-triggered, if the underlying event base backend supports edge-triggered events. This affects the semantics of Event::READ and Event::WRITE .

Event::PERSIST

Indicates that the event is persistent. See About event persistence .

Event::READ

This flag indicates an event that becomes active when the provided file descriptor(usually a stream resource, or socket) is ready for reading.

Event::WRITE

This flag indicates an event that becomes active when the provided file descriptor(usually a stream resource, or socket) is ready for reading.

Event::SIGNAL

Used to implement signal detection. See "Constructing signal events" below.

Event::TIMEOUT

This flag indicates an event that becomes active after a timeout elapses.

The Event::TIMEOUT flag is ignored when constructing an event: one can either set a timeout when event is added , or not. It is set in the $what argument to the callback function when a timeout has occurred.

Table of Contents

add a note add a note

User Contributed Notes

There are no user contributed notes for this page.
To Top